Resumo O objetivo do presente trabalho é a análise qualitativa da variação de temperatura em ambos os lados da junta soldada, de forma a verificar se esta variabilidade pode ter contribuído no aparecimento de descontinuidades, em destaque a falta de fusão lateral. O aparecimento da descontinuidade pode estar relacionado com a diferença de temperatura em ambos os lados da junta, causada como por exemplo pela quantidade de massa desigual nos dois lados. Para determinar se essas características interferem, foram realizadas soldagens em dutos testes com 3 tubos e 2 tubos, observando-se o regime térmico em pontos simétricos com uso de uma câmera termográfica. As soldagens foram conduzidas em progressão descendente e mecanizada, utilizando-se arame ER70S-6 com 1,2 mm de diâmetro, protegido pela mistura de Ar+25%CO2 com vazão de 15 l/min em dutos de aço carbono API 5L X42 de 8” de diâmetro e 8,0 mm de espessura. O material foi depositado em junta de topo com chanfro em V e bisel de 15º, 1 mm de altura de nariz, 3 mm de abertura de raiz e sem cobre-junta. Para a junta proposta foi avaliado o processo GMAW derivativo STT (Surface Tension Transfer). Conclui-se que a diferença da temperatura nos lados do duto não afeta a soldagem em geral, sendo a diferença máxima de temperatura entre ambos os lados para pontos simétricos de 4 °C. Já a montagem com dois ou três seções de tubos testes não interferiu significativamente nos resultados.
Abstract This work presents a qualitative analysis of the decrease or increase of the difference temperature in the pipeline through graphics in order to verify if the mass difference and unknown parameters (density etc.) existing on both sides of the installation contributes to the emergence of discontinuities (highlighted the lack of lateral fusion). To determine if these characteristics affect, were carried welds in pipe, observing the thermal flow with use of a thermographic camera in order to analyze the variation of temperature in symmetrical points. The welds were carried out in downhill progression by using orbital displacement device (mechanized welding), ER70S-6 wire with 1.2 mm diameter and Ar+25%CO2, as shielding gas (15 l/min). The material was deposited on butt V joint with 15º bevel, 1 mm of root face and 3 mm root opening, without backing. For the proposed joint, GMAW processes with short-circuit metal transfer was assessed the derivative mode by using commercial power source namely STT (Surface Tension Transfer). In this context, decrease and increase temperature was investigated for root pass and filling pass. Were carried out a total of 12 welds (6 root pass and 6 filling passes) in two test pipe (with 3 tubes and 2 tubes). After, the recording files ceded by the thermographic camera were decoded and analyzed with of Matlab and OriginPRO® software. The results showed that the rate decrease of temperature the in both sides of the pipe doesn't affect the welding generally because the temperature difference in both sides for symmetrical points in the worst case it's 4 °C.